Feet to Metres Converter

Feet ↔ metres

Your result will appear here
1 foot = 0.3048 metres

Enter a measurement, pick the direction, and convert. A foot is defined as exactly 0.3048 metres, so the arithmetic is settled; what trips people up is the notation feet are usually written in, and that is what the notes below are about.

How to use it

  1. Type the measurement into Value, then set From and To.
  2. Press Convert or the Enter key. The swap button reverses the direction; convert again to refresh.
  3. Decimals cycles how many places are shown, and Copy result puts the figure on your clipboard.

The formula

metres = feet × 0.3048
feet = metres ÷ 0.3048

Roughly, a metre is a bit over three feet. That is close enough to judge whether a ceiling is high or a room is long, and not close enough for anything you are going to cut or order.

Feet and inches are not decimals

This is the error that matters. A measurement written 8′ 6″ means eight feet and six inches. Six inches is half a foot, so the value is 8.5 feet, which converts to 2.591 metres. Typing 8.6 instead gives 2.621 metres, an error of three centimetres that will show up when the piece does not fit. Divide the inches by twelve before you convert.

Quick reference

FeetMetres
10.3048
30.9144
61.8288
103.048
206.096
5015.24
10030.48

Where it comes up

Room dimensions, ceiling heights, plot sizes, timber lengths and diving depths all move between the two systems depending on who wrote the document. Floor plans are the common case: a plan drawn in feet and a supplier quoting in metres need one of the two converting before anyone orders material.

Length only, not area

Square feet do not convert with this factor. One square metre is about 10.76 square feet, because the factor applies to each dimension. If you are pricing flooring or paint, convert the room’s length and width separately and calculate the area afterwards.

How many decimals to keep

Four decimal places on a metre is a tenth of a millimetre, which is finer than a tape measure can read. For building work, two places is plenty; for joinery, three. Match the precision to the measurement you started with, and write the unit beside the number every time.

Frequently asked questions

Is 0.3048 exact?

Yes. The international foot is defined as exactly 0.3048 metres. The older US survey foot differs very slightly and is only used in legacy land surveying.

Can I enter feet and inches together?

Not as one entry. Convert the inches to a fraction of a foot first by dividing by twelve, then enter the single decimal figure.

Scroll to Top